Subject	Correct...
Posted by	The Sixth on January 13, 2015 at 2:49 PM
	This message has been viewed 265 times.
In Reply To	Good idea, problem is I have the engine halfway disassembled posted by Tanley on January 13, 2015 at 02:03 PM
Message	But yes, mine was still fully assembled so easy to get off the stand. I've always used tow straps run under my plenum. I'm sure there's a way to wrap some long ones around the block in a secure way. And since your block is inverted you probably don't even need a cradle so much as couple blocks of wood to set it on. I'm sure this isn't so much the answer you're looking for as opposed to a workaround. It was much nicer than working under the car to get access to the backside.
Follow Ups	Rear Main Seal Retainer Plate Install - Tanley 21:42:55 01/11/15 Re: Rear Main Seal Retainer Plate Install - The Sixth 10:59:47 01/12/15 Good idea, problem is I have the engine halfway disassembled - Tanley 14:03:54 01/13/15 Correct... - The Sixth 14:49:32 01/13/15 I bolted the motor mounrs on - -Grimm- 10:55:43 01/14/15 The Sixth/Grimm thanks for the help, was able to get it up - Tanley 16:46:26 01/18/15 Good to hear! (n/m) - The Sixth 10:51:38 01/19/15
Post a Followup	You cannot reply to this message because you are not logged in.