TwinTurbo.NET: Nissan 300ZX forum - Good idea, problem is I have the engine halfway disassembled
Subject
Good idea, problem is I have the engine halfway disassembled
Posted by
Tanley
on January 13, 2015 at 2:03 PM
This message has been viewed
209
times.
In Reply To
Re: Rear Main Seal Retainer Plate Install
posted by The Sixth
on January 12, 2015 at 10:59 AM
Message
inverted on the engine stand. How did you get your engine onto the cradle? Using an engine hoist? I'm trying to figure out where I can mount the hoist to lift it while inverted.
Follow Ups
Rear Main Seal Retainer Plate Install
-
Tanley
21:42:55 01/11/15
Re: Rear Main Seal Retainer Plate Install
-
The Sixth
10:59:47 01/12/15
Good idea, problem is I have the engine halfway disassembled -
Tanley
14:03:54 01/13/15
Correct...
-
The Sixth
14:49:32 01/13/15
I bolted the motor mounrs on
-
-Grimm-
10:55:43 01/14/15
The Sixth/Grimm thanks for the help, was able to get it up
-
Tanley
16:46:26 01/18/15
Good to hear! (n/m)
-
The Sixth
10:51:38 01/19/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.