Subject	Put a vacuum gage on the engine and run it and read the >>
Posted by	ZUL8TR on December 30, 2014 at 4:14 AM
	This message has been viewed 266 times.
In Reply To	Got all the hoses done posted by Z32CheekiBreeki on December 28, 2014 at 07:52 PM
Message	dial. Here are tips on reading the needle variations. [ http://www.atlanticz.ca/zclub/techtips/vacuum/ ] I use injector cleaner spray to check for leak locations while looking at the vacuum gage response. ZUL8TR in Orlando,FL
Follow Ups	Need help with vacuum routing on an NA - Z32CheekiBreeki 12:47:53 12/28/14 Figured it out! - Z32CheekiBreeki 14:01:14 12/28/14 FWIW: With the battery out that EGR vacuum nose isn't too - jzack 10:00:51 12/29/14 1/4" = 6.35mm so it will not be as tight a fit as 6mm.>> - ZUL8TR 16:54:37 12/28/14 Got all the hoses done - Z32CheekiBreeki 19:52:02 12/28/14 Spray some brake cleaner in that area, and listen - ttz'in (norcal) 22:48:03 12/28/14 Put a vacuum gage on the engine and run it and read the >> - ZUL8TR 04:14:38 12/30/14 Well sprayed lots of carb cleaner in the area - Z32CheekiBreeki 14:52:10 12/30/14 Vac gage might reveal issues you don't even notice>> - ZUL8TR 04:43:26 12/31/14
Post a Followup	You cannot reply to this message because you are not logged in.