Subject	Yeah, it was obvious what areas had failed. One
Posted by	doug8867 on December 27, 2014 at 9:04 AM
	This message has been viewed 173 times.
In Reply To	Pull the controller apart and look for bad solder joints posted by ttsmokin on December 22, 2014 at 11:18 PM
Message	capacitor was blackened with burn marks on the board. I also had one of the two 3 pin resistors on each side of the case that showed signs of overheating as the solder joints were grey and dull, instead of shiny like all the other joints, and also slight blackening around the circuit board holes where they connnected.
Follow Ups	Odd coincidence or one problem finally solved! - doug8867 20:00:57 12/22/14 Thx for posting - always good to see follow-ups to - jzack 21:37:24 12/22/14 Pull the controller apart and look for bad solder joints - ttsmokin 23:18:05 12/22/14 Yeah, it was obvious what areas had failed. One - doug8867 09:04:33 12/27/14 Real nice to see a follow up. - Frldy_Z 00:22:03 12/23/14 I didn't mention the original problem I was having - doug8867 09:00:27 12/27/14
Post a Followup	You cannot reply to this message because you are not logged in.