Subject	setting tps with datascan???
Posted by	LivinTheDream on December 25, 2014 at 7:31 PM
	This message has been viewed 441 times.
Message	Hooked up datascan and saw that the tps reading was bliping between 44 and 42. I did nothing but loosen the bolts slightly while looking at datascan and put a little pressure on it tell it read a steady 44. Couldn't get 45. It was either 44 or 46. Tightened the bolts and left it alone. No unplugging no multimeter. Are we cool??? "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	setting tps with datascan??? - LivinTheDream 19:31:11 12/25/14 TPS setting - ZUL8TR 06:11:28 12/26/14 it reads .44 closed also 'ON' - closed TPS at the same time - LivinTheDream 21:46:35 12/26/14 The hard idle switch needs to be just comming on >> - ZUL8TR 06:08:49 12/27/14 So ........(bare with me) - LivinTheDream 11:54:31 12/27/14 Nothing optimal about 0.45V. Voltage should be in the >> - ZUL8TR 03:43:33 12/28/14
Post a Followup	You cannot reply to this message because you are not logged in.