Subject	Follow up Q for all those who installed adj arms
Posted by	evan_aggie on December 17, 2014 at 11:07 PM
	This message has been viewed 217 times.
In Reply To	Control Arm Install - OEM Bracket Isolation Foam? posted by evan_aggie on December 17, 2014 at 02:30 PM
Message	All the instructions say to put the bolts + nut through the arms and tighten them but not to max torque until the car is under weight. How in the hell could you ever torque them unless you had some fancy torque wrenches since there is NO room to fit the head of a torque wrench with socket once the arm is in position (the engine side bolt). I don't see how it is physically possible.
Follow Ups	Control Arm Install - OEM Bracket Isolation Foam? - evan_aggie 14:30:22 12/17/14 Follow up Q for all those who installed adj arms - evan_aggie 23:07:12 12/17/14 Those are upper control arm brackets. From the - LivinTheDream 11:44:08 12/18/14 there is no need to torque them under weight - aliaZ 14:15:36 12/18/14 Thanks! Spencer @ Z1 told me their instructions were wrong. (n/m) - evan_aggie 17:19:14 12/18/14
Post a Followup	You cannot reply to this message because you are not logged in.