TwinTurbo.NET: Nissan 300ZX forum - Re: glazed cylinders
People Seeking Info
 
   


     
Subject Re: glazed cylinders
     
Posted by Tech@EPR on December 13, 2014 at 1:33 AM
  This message has been viewed 215 times.
     
In Reply To glazed cylinders posted by Barthur on December 10, 2014 at 02:33 PM
     
Message .004" is perfectly fine but did you physically measure your clearance yourself or are you going off what the machine shop told you? Reason I ask is because that looks like you have too tight of oil clearance for piston to wall in that block. At .004" you would of never had glazed cylinders unless you experienced bore wash from fuel saturation.

Ep Racing | Create Your Badge

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.