Subject	I would suggest
Posted by	Frldy_Z on December 01, 2014 at 8:13 PM
	This message has been viewed 252 times.
In Reply To	so ok left as is? (n/m) posted by FrozTTy on December 01, 2014 at 02:35 PM
Message	tracing the lines to see where they go. I would also find where the oil cooler feed line is. US spec is located on the oil filter tree. I would also make sure that the oil cooler return line is plugged on the oil pan.
Follow Ups	Educate Me - FrozTTy 09:14:07 12/01/14 Is that a RHD? - -Grimm- 09:55:23 12/01/14 Yes they look like RHD oil cooler lines. - Frldy_Z 10:23:53 12/01/14 You guys are on the 'right' track - FrozTTy 10:27:46 12/01/14 Re: You guys are on the 'right' track - Frldy_Z 10:35:15 12/01/14 The oil filter tree has the feed for RHD oil cooler - ttsmokin 14:23:02 12/01/14 so ok left as is? (n/m) - FrozTTy 14:35:17 12/01/14 Well if nothing is spraying oil out, it must be blocked off - ttsmokin 15:40:15 12/01/14 Nope... not using oil cooler right now. - FrozTTy 09:14:01 12/03/14 Nevermind.... I know what's in store for me next - FrozTTy 07:22:49 12/04/14 I would suggest - Frldy_Z 20:13:24 12/01/14 HAHA mr funny guy. - Frldy_Z 20:20:11 12/01/14 hard to find good mechanics nowadays.... it's SAD - FrozTTy 09:06:26 12/02/14 The casting of the blocks should be the same - Frldy_Z 11:43:01 12/02/14 IDK why there would be an NA filter tree on the motor. - FrozTTy 11:51:27 12/02/14 I don't have much experience with JDM motors as I tend - Frldy_Z 12:23:22 12/02/14 Thanks for your help. Do you have a pic of the - FrozTTy 09:46:43 12/03/14 Re: Thanks for your help. Do you have a pic of the - ttz'in (NorCal) 13:45:26 12/04/14 Reference pic - Frldy_Z 12:43:29 12/02/14 ^Much better (n/m) - -Grimm- 10:06:01 12/02/14
Post a Followup	You cannot reply to this message because you are not logged in.