Subject	Maybe you could explain a bit more on how this
Posted by	jzack on November 30, 2014 at 8:33 AM
	This message has been viewed 251 times.
In Reply To	How would I get my crankshaft pulley off? posted by Devonz32 on November 30, 2014 at 04:17 AM
Message	happened? Was it a bad re-install? Hard to believe it would even go on like that? - there's normally not a lot of play between the pulley hole and shaft.... Maybe try a rubber mallet and see if whacking it the right way can get it to align straight?
Follow Ups	How would I get my crankshaft pulley off? - Devonz32 04:17:06 11/30/14 Maybe you could explain a bit more on how this - jzack 08:33:23 11/30/14 Re: Maybe you could explain a bit more on how this - MaxxAction 13:42:21 11/30/14 Long soak with PB Blaster, or torch the pulley - ttz'in (NorCal) 12:54:02 11/30/14 here is a video of the pulley when the car is on - Devonz32 16:26:04 11/30/14 Re: I have after market pulley also - ZTom 17:43:00 11/30/14 you need a new crank (n/m) - aliaZ 12:07:35 12/01/14 Re: How would I get my crankshaft pulley off? - MaxxAction 21:58:46 11/30/14 Sounds like it's time for a rebuild.... - Frldy_Z 22:54:31 11/30/14
Post a Followup	You cannot reply to this message because you are not logged in.