TwinTurbo.NET: Nissan 300ZX forum - I've used that type of Iron before.. to each his own..
Subject
I've used that type of Iron before.. to each his own..
Posted by
Cjw3
on November 25, 2014 at 11:06 PM
This message has been viewed
626
times.
In Reply To
Much safer than dremel and tweezers...
posted by Ted (92TT)
on November 25, 2014 at 07:28 PM
Message
I think it's to much heat stress on the Circuit board.. pulling the legs one at a time is gentler in my opinion.
Cj
Follow Ups
Chipping the ECU
-
Cjw3
12:19:36 11/23/14
Nice job. You can also use a small pair
-
xpwarrior
12:45:34 11/23/14
great write-up! VTF'd (n/m)
-
zromtech
20:15:39 11/23/14
Very nice! (n/m)
-
OverZealous (CT)
21:05:46 11/23/14
Awesome Job! I was going to mention Nail Polish Remover
-
Red Hawk (CO)
16:07:14 11/24/14
Wow, more than I would ever tackle but nice job! (n/m)
-
doug8867
18:13:40 11/24/14
Great write up CJ! Glad mine was already socketed. (n/m)
-
SammybTT(TN)
21:24:05 11/24/14
I know who I'm contacting if I ever need an ECU socketed
-
spicyZ
07:52:48 11/25/14
Thanks Guys
-
Cjw3
10:23:39 11/25/14
Re: Thanks Guys
-
zromtech
14:47:37 11/26/14
I was able to find another copy of the Tuner Guide.
-
Cjw3
14:39:29 11/30/14
Much safer than dremel and tweezers...
-
Ted (92TT)
19:28:26 11/25/14
I've used that type of Iron before.. to each his own.. -
Cjw3
23:06:53 11/25/14
heat gun works well to soften the conformal coating (n/m)
-
aliaZ
19:54:53 11/25/14
Post a
Followup
You cannot reply to this message because you are not
logged in
.