Subject	It's a lot easier to just break the connection going up
Posted by	jzack on November 23, 2014 at 11:21 PM
	This message has been viewed 687 times.
In Reply To	Third brake light out, time to get rid of that warning light posted by jkeyser14 on November 22, 2014 at 06:28 PM
Message	to the dash light. One little wire snipe and all done. Seems like a lot of extra working removing all those board components.
Follow Ups	Third brake light out, time to get rid of that warning light - jkeyser14 18:28:08 11/22/14 Well done. Picture of connections ? (n/m) - ttz'in (NorCal) 03:11:16 11/23/14 Re: Well done. Picture of connections ? - jkeyser14 14:10:35 11/23/14 Gotcha, thanks. (n/m) - ttz'in (NorCal) 12:49:08 11/24/14 It's a lot easier to just break the connection going up - jzack 23:21:32 11/23/14 true, but my sensor was bad. Third brake light not working. (n/m) - jkeyser14 06:49:52 11/24/14 You could also solder the wires together directly - xpwarrior 12:44:38 11/24/14 No more bad bulb warning either thou, right? (n/m) - LivinTheDream 18:57:26 11/24/14 Re: No more bad bulb warning either thou, right? - jkeyser14 19:33:01 11/24/14
Post a Followup	You cannot reply to this message because you are not logged in.