Subject	Crimps are often the preferred splice method
Posted by	BlackholeZ on November 22, 2014 at 1:01 PM
	This message has been viewed 418 times.
In Reply To	Dremel the plenum at the appropriate locations to allow>> posted by ZUL8TR on November 22, 2014 at 11:15 AM
Message	Like you said when done well they are solid. Adhesive lined heat shrink is the hero here. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Think I'm missing something on my plenum pull - Matt300ZXT 16:10:16 11/21/14 Coolant hose if you haven't done delete. (n/m) - ttz'in (NorCal) 17:55:37 11/21/14 Re: Coolant hose if you haven't done delete. - Matt300ZXT 19:41:03 11/21/14 Dremel the plenum at the appropriate locations to allow>> - ZUL8TR 11:15:23 11/22/14 Crimps are often the preferred splice method - BlackholeZ 13:01:59 11/22/14 I disagree, solder is far better and easy to learn - -Grimm- 13:43:48 11/22/14 Re: I disagree, solder is far better and easy to learn - Matt300ZXT 15:01:11 11/22/14 so are you going for the new style injectors and using >> - ZUL8TR 16:47:22 11/22/14 Re: so are you going for the new style injectors and using >> - Matt300ZXT 17:09:04 11/22/14 so far 2 to 1 on crimps, they do work well need correct >>. - ZUL8TR 16:46:01 11/22/14 Yeah, theyre even worse when bad tooling is used - -Grimm- 18:00:06 11/22/14 ^2nd^ (n/m) - ttz'in (NorCal) 03:52:36 11/23/14 Now 2 to 2! I agree solder is great. Been using >>> - ZUL8TR 07:12:51 11/23/14
Post a Followup	You cannot reply to this message because you are not logged in.