Subject	Wheel Stud Removal - To hammer or press out?
Posted by	evan_aggie on November 16, 2014 at 11:21 PM
	This message has been viewed 385 times.
Message	I see a lot of people show the method of using a mini sledge to hammer out original studs. Is it just me or isn't there some small risk you damage the wheel bearings? It feels like stud removal tool (also looks like a tie-rod tool) would be best. Thoughts?
Follow Ups	Wheel Stud Removal - To hammer or press out? - evan_aggie 23:21:30 11/16/14 Hammering is not good unless you can support the - JMartz 08:41:21 11/17/14 Press - -Grimm- 10:43:01 11/17/14 That's what i thought? How come so many ppl hammer? - evan_aggie 11:17:45 11/17/14 Because people enjoy replacing wheel bearings (n/m) - -Grimm- 09:38:59 11/18/14 Never had a problem with hammering a stud out - Stanky 13:39:16 11/17/14 Re: Wheel Stud Removal - To hammer or press out? - WazTTed 16:42:17 11/17/14 2nd. Few sharp raps with mini sledge and out they pop (n/m) - doug8867 19:01:39 11/17/14
Post a Followup	You cannot reply to this message because you are not logged in.