Subject	Re: Forgot to mention
Posted by	Kvert on November 15, 2014 at 10:52 PM
	This message has been viewed 500 times.
In Reply To	Forgot to mention posted by Z32CheekiBreeki on November 15, 2014 at 08:25 AM
Message	"Fairly short" is a bit relative. Just make sure it reaches the injector before cutting the old one and soldering in place. :) Also make sure you shrink wrap the solder joint. Don't tape it.
Follow Ups	Injector Replacement Help - Z32CheekiBreeki 14:27:09 11/13/14 The plastic caps on the old injectors? - -Grimm- 15:00:50 11/13/14 Should have addressed more in that post - -Grimm- 15:02:37 11/13/14 Air pressure test the injectors on the fuel rail B4 >>> - ZUL8TR 06:32:25 11/17/14 When redoing the connectors to the new style >>> - ZUL8TR 06:37:14 11/17/14 would pressurizing the rail with fuel be just as good??? (n/m) - LivinTheDream 06:40:57 11/20/14 No.The leak test is before the install on the engine >> - ZUL8TR 02:23:55 11/21/14 I mean hooking up the fuel lines before installing the rail? - LivinTheDream 12:49:31 11/21/14 PS: When doing this test have a shut off valve in >>` - ZUL8TR 02:30:01 11/21/14 they should be fine if no mechanical damage seen - itsa300zx 16:04:54 11/13/14 Yeah no damage as far as I can tell - Z32CheekiBreeki 16:47:32 11/13/14 if you don't have access to a sonic cleaner, I would just - itsa300zx 17:12:53 11/13/14 the injectors im trying to get out and re use are new style - Z32CheekiBreeki 17:46:48 11/13/14 Carb cleaner would be fine - -Grimm- 18:10:20 11/13/14 Nearly impossible to get them out without damaging the caps - ZXoltan 16:30:43 11/14/14 Re: Injector Replacement Help - Kvert 17:27:19 11/14/14 Re: Re: Injector Replacement Help - Kvert 17:37:52 11/14/14 Excellent - Z32CheekiBreeki 08:21:28 11/15/14 Forgot to mention - Z32CheekiBreeki 08:25:07 11/15/14 Re: Forgot to mention - Kvert 22:52:15 11/15/14
Post a Followup	You cannot reply to this message because you are not logged in.