TwinTurbo.NET: Nissan 300ZX forum - Walbro 485 install kit questions
People Seeking Info
 
   


     
Subject Walbro 485 install kit questions
     
Posted by SammybTT(TN) on November 15, 2014 at 8:32 PM
  This message has been viewed 1047 times.
     
     
Message Well I'm finally finding time to install my Walbro 485 fuel pump. While laying the fuel pump and install kit components out on the bench before starting I noticed a short piece of fuel hose.

Question 1: Is the hose that is included in the Walbro install kit submersible fuel hose?

Question 2: What size (I believe it is 5/16) and what length of the submersible hose is required?

Question 3: What type of material is used to isolate the fuel pump from the metal hanger?

Question 4: I noticed that most people use 2 worm gear hose clamps to secure the pump to the hanger. Is there a material requirement for the hose clamps?

Thanks for looking any information shared would be appreciated.

Cheers,

Sammy

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.