Subject	Re: I've never had an issue just cleaning it out and coating it.
Posted by	backinblack626 on November 14, 2014 at 9:01 AM
	This message has been viewed 459 times.
In Reply To	I've never had an issue just cleaning it out and coating it. posted by Woody75 (Denver) on November 13, 2014 at 02:00 PM
Message	What temps did you guys bake at? no leakage around the cap of the reservoir? It was recommended to me that I remove the filter since it would seep out when baked. also recommended that I cure at 200 degrees for a longer time rather than 400 for shorter time.
Follow Ups	Powder Coating PS Reservior - backinblack626 12:32:13 11/13/14 I've never had an issue just cleaning it out and coating it. - Woody75 (Denver) 14:00:45 11/13/14 ^^^Ditto (n/m) - ZaXxon 04:37:06 11/14/14 Re: I've never had an issue just cleaning it out and coating it. - backinblack626 09:01:48 11/14/14 I do it normal. - Woody75 (Denver) 09:23:02 11/14/14 what temp do you have to bake it at? (n/m) - aliaZ 09:42:59 11/14/14 I want to say its 350-400 but I dont remember. (n/m) - Woody75 (Denver) 11:29:27 11/14/14 350 is common for light/medium PC (n/m) - -Grimm- 16:45:50 11/14/14 I did wrinkle red, 375 for 15 minutes. (n/m) - ZaXxon 06:29:50 11/16/14
Post a Followup	You cannot reply to this message because you are not logged in.