Subject	Ensure that the injector connector isn't loose. I had a
Posted by	ZaXxon on November 14, 2014 at 4:41 AM
	This message has been viewed 453 times.
In Reply To	Did injector tests today, I'm quite confused posted by Matt300ZXT on November 12, 2014 at 12:57 PM
Message	misfire problem after I swapped connectors because one of the wires was loose in pin.
Follow Ups	Did injector tests today, I'm quite confused - Matt300ZXT 12:57:35 11/12/14 This makes no sense - spicyZ 13:08:59 11/12/14 Re: This makes no sense - Matt300ZXT 13:19:33 11/12/14 Are you sure you had the right wire for injector 3? (n/m) - spicyZ 14:50:57 11/12/14 Seeing as your issues are on the same bank - FrozTTy 13:43:06 11/12/14 Re: Seeing as your issues are on the same bank - Matt300ZXT 13:54:22 11/12/14 Matt, the ground wire splice is so ez. (n/m) - ttz'in (NorCal) 14:00:52 11/12/14 Re: Matt, the ground wire splice is so ez. - Matt300ZXT 14:50:24 11/12/14 That would put the spark for cyl 3 - -Grimm- 14:56:52 11/12/14 thats what im thinking (n/m) - LivinTheDream 15:11:38 11/12/14 Do you have de-electric grease on the connectors? - LivinTheDream 14:52:55 11/12/14 also double check that you are testing the right terminals - LivinTheDream 15:07:27 11/12/14 Re: also double check that you are testing the right terminals - Matt300ZXT 15:14:38 11/12/14 Re: Re: also double check that you are testing the right terminals - Matt300ZXT 15:59:26 11/12/14 I dont know how to test it either. clean it up and - LivinTheDream 18:18:29 11/12/14 Bypass the subharness connectors - -Grimm- 09:22:49 11/13/14 wiring is so fun: - LivinTheDream 17:47:42 11/12/14 Re: wiring is so fun: - Matt300ZXT 18:05:25 11/12/14 U'll get it. Seems like a pain but get some rest, place your - LivinTheDream 18:27:45 11/12/14 lastly pull which ever coil pack is not adjusting idle - LivinTheDream 18:48:43 11/12/14 ^Or no compression - -Grimm- 09:23:57 11/13/14 leak down test? whats the fix? (n/m) - LivinTheDream 15:42:53 11/13/14 Leakdown or Bore scope - -Grimm- 18:11:45 11/13/14 Ensure that the injector connector isn't loose. I had a - ZaXxon 04:41:34 11/14/14
Post a Followup	You cannot reply to this message because you are not logged in.