Subject	Or pressed against the EFI harness ?
Posted by	ttz'in (NorCal) on November 04, 2014 at 3:06 AM
	This message has been viewed 334 times.
In Reply To	Oil Dipstick Tube posted by FrozTTy on November 03, 2014 at 01:56 PM
Message	Either way, a picture would help. Carefully with good lighting, a small prybar or large screwdriver gently pry (probably towards brake master) only enough clearance to remove dipstick. Ok jimmy ? Then ASAP have someone with Z32 knowledge take a look.
Follow Ups	Oil Dipstick Tube - FrozTTy 13:56:58 11/03/14 Or pressed against the EFI harness ? - ttz'in (NorCal) 03:06:22 11/04/14 I'm not Jimmy, but you can call me Al.... - FrozTTy 07:51:58 11/04/14 lol, Ok Al, but why is life so hard .... - ttz'in (NorCal) 12:25:03 11/04/14 Should have idle issue if DS not sealing properly. - ttz'in (NorCal) 03:09:50 11/04/14 Pics >>>> - FrozTTy 09:38:27 11/04/14 The tube is fairly pliable - -Grimm- 10:19:24 11/04/14 Thanks... and I hear ya... yea it is!!! (n/m) - FrozTTy 10:24:42 11/04/14 Is that the correct location (in general) - FrozTTy 10:25:41 11/04/14 Pretty much. DS never was ez to access, especially - ttz'in (NorCal) 12:33:17 11/04/14 Very good, thanks Al. Per last picture, just tweak it - ttz'in (NorCal) 12:29:38 11/04/14 Perfect, thanks. - FrozTTy 13:04:53 11/04/14 Probably good as anyplace to start. (n/m) - ttz'in (NorCal) 13:25:16 11/04/14 Anyone else ever have this issue to correct? - FrozTTy 11:43:57 11/06/14
Post a Followup	You cannot reply to this message because you are not logged in.