Subject	Two bolts loosely fastended, a mallet, some shaking..
Posted by	LivinTheDream on November 01, 2014 at 7:24 PM
	This message has been viewed 332 times.
In Reply To	Thanks guys. see how this goes. posted by LivinTheDream on October 28, 2014 at 03:48 PM
Message	Thumbs up. Its off. I used a silicone jack pad and a hammer since I didn't have the mallet. Hold up the jack pad, knock knock with the hammer here and there and bam. "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	flywheel is stuck on crank? removal tips?? bolts are out. - LivinTheDream 20:19:11 10/27/14 I vote yes on anti-sleaze. - OverZealous (CT) 20:41:38 10/27/14 Put a couple bolts back on loosely and hit FW with mallet. (n/m) - itsa300zx 22:32:59 10/27/14 Whack it with a mallet. Grab with both hands and rock it - ThisIsSparTTa 12:45:54 10/28/14 Thanks guys. see how this goes. - LivinTheDream 15:48:36 10/28/14 Two bolts loosely fastended, a mallet, some shaking.. - LivinTheDream 19:24:29 11/01/14
Post a Followup	You cannot reply to this message because you are not logged in.