Subject	are you sure the injector is firing?
Posted by	LivinTheDream on October 28, 2014 at 8:05 AM
	This message has been viewed 346 times.
In Reply To	Dead cylinder posted by DEcosse on October 27, 2014 at 04:10 PM
Message	Make sure you are getting the correct power to the injector. U can use an led to the injector feeds and check if it blinks when cranking. If the injector is getting the proper signal maybe its not spraying. You can disconnect the coil pack. Crank the engine a few times then pull the plug to see if its wet or if you smell gas on it. By the o2 test you did it could be a bad o2 sensor. I thought that test is to check the sensor itself but maybe its just to check the firing condition of the engine. Not certain. "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	Dead cylinder - DEcosse 16:10:45 10/27/14 Re: Dead cylinder - DEcosse 16:14:09 10/27/14 Re: Dead cylinder - DEcosse 19:02:38 10/27/14 Re: Dead cylinder - DEcosse 20:36:31 10/27/14 are you sure the injector is firing? - LivinTheDream 08:05:59 10/28/14 or just try another injector connector on the #5 injector (n/m) - LivinTheDream 08:08:07 10/28/14 Re: Dead cylinder - DEcosse 02:21:48 11/04/14 Did you perform an OHM test on the injector or - John (MD) 17:38:46 11/04/14 Re: Did you perform an OHM test on the injector or - DEcosse 04:30:05 11/05/14 Where are you located? - -Grimm- 09:29:02 11/05/14
Post a Followup	You cannot reply to this message because you are not logged in.