TwinTurbo.NET: Nissan 300ZX forum - Bent Valves Replacement Question
People Seeking Info
 
   


     
Subject Bent Valves Replacement Question
     
Posted by macwizz77 on October 23, 2014 at 11:01 PM
  This message has been viewed 482 times.
     
     
Message So here is what happened to my 94' 300zx tt
I was in the burger king drive through and my car died, long story short idler pulley bearing broke and valves bent. All of my exhaust valves on drivers side are bent and everythng else seems to be alright. I have a complete N/A engine sitting in my garage. i'm wondering if i should replace the 6 bent exhaust valves on my tt heads and if so would i have to replace guides or anything else along with the valve or could i get away with just replacing the bent valves? car was idling when the belt slipped or whatever happened. Or i can take the N/A heads and put them on my TT block. What would be the best route to take? i originally got the car from my best friend before he past away for $500 due to it not having a title and was running great and now i have a title and need to rebuild the engine so i can sell it.
Thanks a ton for any input!!
Mike

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.