TwinTurbo.NET: Nissan 300ZX forum - All installed with the markings facing upwards? (n/m)
Subject
All installed with the markings facing upwards? (n/m)
Posted by
-Grimm-
on October 22, 2014 at 4:56 PM
This message has been viewed
205
times.
In Reply To
Top, 2nd, and oil rings were all offset to each other proper
posted by Barthur
on October 22, 2014 at 07:19 AM
Message
Follow Ups
burning oil after rebuild
-
Barthur
08:49:48 10/21/14
Who built the engine?
-
-Grimm-
09:35:01 10/21/14
Re: Who built the engine?
-
Barthur
10:30:43 10/21/14
How was your piston ring alignment and direction (n/m)
-
-Grimm-
14:28:57 10/21/14
Top, 2nd, and oil rings were all offset to each other proper
-
Barthur
07:19:37 10/22/14
All installed with the markings facing upwards? (n/m) -
-Grimm-
16:56:46 10/22/14
What was your break-in procedure? (n/m)
-
SammybTT(TN)
10:08:49 10/21/14
.........Did the smoking and oil consumption start with the
-
SammybTT(TN)
10:14:02 10/21/14
Re: .........Did the smoking and oil consumption start with the
-
Barthur
10:36:47 10/21/14
Re: burning oil after rebuild
-
MaxxAction
11:07:06 10/21/14
Re: Re: burning oil after rebuild
-
Barthur
12:37:00 10/21/14
Re: Re: Re: burning oil after rebuild
-
MaxxAction
16:10:18 10/21/14
There has to be a gap
-
-Grimm-
14:26:49 10/21/14
Do you know what the ring material is? Different ring
-
SirpriZ
14:21:43 10/21/14
Given your compression numbers and recent rebuild
-
JMartz
14:46:54 10/21/14
Re: Given your compression numbers and recent rebuild
-
Barthur
19:44:05 10/21/14
please keep us updated
-
wickdGSXR
10:39:27 10/23/14
Post a
Followup
You cannot reply to this message because you are not
logged in
.