Subject	How was your piston ring alignment and direction (n/m)
Posted by	-Grimm- on October 21, 2014 at 2:28 PM
	This message has been viewed 237 times.
In Reply To	Re: Who built the engine? posted by Barthur on October 21, 2014 at 10:30 AM
Message
Follow Ups	burning oil after rebuild - Barthur 08:49:48 10/21/14 Who built the engine? - -Grimm- 09:35:01 10/21/14 Re: Who built the engine? - Barthur 10:30:43 10/21/14 How was your piston ring alignment and direction (n/m) - -Grimm- 14:28:57 10/21/14 Top, 2nd, and oil rings were all offset to each other proper - Barthur 07:19:37 10/22/14 All installed with the markings facing upwards? (n/m) - -Grimm- 16:56:46 10/22/14 What was your break-in procedure? (n/m) - SammybTT(TN) 10:08:49 10/21/14 .........Did the smoking and oil consumption start with the - SammybTT(TN) 10:14:02 10/21/14 Re: .........Did the smoking and oil consumption start with the - Barthur 10:36:47 10/21/14 Re: burning oil after rebuild - MaxxAction 11:07:06 10/21/14 Re: Re: burning oil after rebuild - Barthur 12:37:00 10/21/14 Re: Re: Re: burning oil after rebuild - MaxxAction 16:10:18 10/21/14 There has to be a gap - -Grimm- 14:26:49 10/21/14 Do you know what the ring material is? Different ring - SirpriZ 14:21:43 10/21/14 Given your compression numbers and recent rebuild - JMartz 14:46:54 10/21/14 Re: Given your compression numbers and recent rebuild - Barthur 19:44:05 10/21/14 please keep us updated - wickdGSXR 10:39:27 10/23/14
Post a Followup	You cannot reply to this message because you are not logged in.