TwinTurbo.NET: Nissan 300ZX forum - .........Did the smoking and oil consumption start with the
Subject
.........Did the smoking and oil consumption start with the
Posted by
SammybTT(TN)
on October 21, 2014 at 10:14 AM
This message has been viewed
249
times.
In Reply To
burning oil after rebuild
posted by Barthur
on October 21, 2014 at 08:49 AM
Message
Initial break in or just recently? That is a lot of oil and with the numbers you provided they don't sound that bad to me but I'm not an expert. Let. E mill around on this for a whe and maybe someone else with more experience will chime in
Follow Ups
burning oil after rebuild
-
Barthur
08:49:48 10/21/14
Who built the engine?
-
-Grimm-
09:35:01 10/21/14
Re: Who built the engine?
-
Barthur
10:30:43 10/21/14
How was your piston ring alignment and direction (n/m)
-
-Grimm-
14:28:57 10/21/14
Top, 2nd, and oil rings were all offset to each other proper
-
Barthur
07:19:37 10/22/14
All installed with the markings facing upwards? (n/m)
-
-Grimm-
16:56:46 10/22/14
What was your break-in procedure? (n/m)
-
SammybTT(TN)
10:08:49 10/21/14
.........Did the smoking and oil consumption start with the -
SammybTT(TN)
10:14:02 10/21/14
Re: .........Did the smoking and oil consumption start with the
-
Barthur
10:36:47 10/21/14
Re: burning oil after rebuild
-
MaxxAction
11:07:06 10/21/14
Re: Re: burning oil after rebuild
-
Barthur
12:37:00 10/21/14
Re: Re: Re: burning oil after rebuild
-
MaxxAction
16:10:18 10/21/14
There has to be a gap
-
-Grimm-
14:26:49 10/21/14
Do you know what the ring material is? Different ring
-
SirpriZ
14:21:43 10/21/14
Given your compression numbers and recent rebuild
-
JMartz
14:46:54 10/21/14
Re: Given your compression numbers and recent rebuild
-
Barthur
19:44:05 10/21/14
please keep us updated
-
wickdGSXR
10:39:27 10/23/14
Post a
Followup
You cannot reply to this message because you are not
logged in
.