Subject	Who built the engine?
Posted by	-Grimm- on October 21, 2014 at 9:35 AM
	This message has been viewed 252 times.
In Reply To	burning oil after rebuild posted by Barthur on October 21, 2014 at 08:49 AM
Message	Look at the intake tract, specifically compressor outlet (blown oil seal) and upper plenum (bad PCV valves). Does your car still have the PCV hoses on the DS exhaust valve cover? ------------------------------------------------------------------ 1992 300ZX NA 5 Sp (Dead) 1990 300ZX NA Auto 2+2 (Dead) 1990 300ZX TT 5 Sp (Est. 400 HP) 1990 300ZX TT 5 Sp (Est. 600 HP) 2004 G35 Sport 6MT (DD)
Follow Ups	burning oil after rebuild - Barthur 08:49:48 10/21/14 Who built the engine? - -Grimm- 09:35:01 10/21/14 Re: Who built the engine? - Barthur 10:30:43 10/21/14 How was your piston ring alignment and direction (n/m) - -Grimm- 14:28:57 10/21/14 Top, 2nd, and oil rings were all offset to each other proper - Barthur 07:19:37 10/22/14 All installed with the markings facing upwards? (n/m) - -Grimm- 16:56:46 10/22/14 What was your break-in procedure? (n/m) - SammybTT(TN) 10:08:49 10/21/14 .........Did the smoking and oil consumption start with the - SammybTT(TN) 10:14:02 10/21/14 Re: .........Did the smoking and oil consumption start with the - Barthur 10:36:47 10/21/14 Re: burning oil after rebuild - MaxxAction 11:07:06 10/21/14 Re: Re: burning oil after rebuild - Barthur 12:37:00 10/21/14 Re: Re: Re: burning oil after rebuild - MaxxAction 16:10:18 10/21/14 There has to be a gap - -Grimm- 14:26:49 10/21/14 Do you know what the ring material is? Different ring - SirpriZ 14:21:43 10/21/14 Given your compression numbers and recent rebuild - JMartz 14:46:54 10/21/14 Re: Given your compression numbers and recent rebuild - Barthur 19:44:05 10/21/14 please keep us updated - wickdGSXR 10:39:27 10/23/14
Post a Followup	You cannot reply to this message because you are not logged in.