Subject	Re: Misfires at idle?
Posted by	Sportzcoop on October 17, 2014 at 11:18 PM
	This message has been viewed 178 times.
In Reply To	Misfires at idle? posted by -Grimm- on October 17, 2014 at 05:23 PM
Message	Also, make sure the ECU chip is seated properly if you changed it recently. The half moon cut-out should line up with the one in the ecu socket. Keep us posted about the PTU. Good luck.
Follow Ups	Bad misfire, hunting idle, no high idle on cold start up - Hydrus (Dallas) 13:08:18 10/15/14 Check water temp sensor, correct NGK plugs ? (n/m) - ttz'in (NorCal) 13:40:40 10/15/14 Replaced coolant temp for ECU and put fresh ngk iridium in. - Hydrus (Dallas) 13:42:11 10/15/14 Is misfire only one cylinder ? (n/m) - ttz'in (NorCal) 14:49:25 10/15/14 I would do a power balance test to determine if it is one - SammybTT(TN) 21:29:07 10/15/14 I replaced it with an autozone one. Picking an oem one up at - Hydrus (Dallas) 21:35:51 10/15/14 Re: I would do a power balance test to determine if it is one - Hydrus (Dallas) 21:37:19 10/15/14 Re: Bad misfire, hunting idle, no high idle on cold start up - Sportzcoop 22:48:31 10/15/14 Re: Re: Bad misfire, hunting idle, no high idle on cold start up - ttz'in (NorCal) 01:54:55 10/16/14 First item is power balance test (n/m) - SammybTT(TN) 12:46:40 10/16/14 Sorry shouldve made a list of everything ive done. - Hydrus (Dallas) 18:41:16 10/16/14 What were the results of the power balance test...? - -Grimm- 09:57:07 10/17/14 All cyclinders are firing and misfires continue. - Hydrus (Dallas) 12:41:26 10/17/14 Misfires at idle? - -Grimm- 17:23:04 10/17/14 Re: Misfires at idle? - Sportzcoop 23:18:50 10/17/14 They were on idle and under load. I knew it wasnt my injecto - Hydrus (Dallas) 17:26:57 10/18/14
Post a Followup	You cannot reply to this message because you are not logged in.