Subject	Re: I've done the non-dash pull way 3 times now.
Posted by	pearlwhite on October 16, 2014 at 4:53 PM
	This message has been viewed 155 times.
In Reply To	I've done the non-dash pull way 3 times now. posted by Woody75 (Denver) on October 15, 2014 at 12:42 PM
Message	My only concern was that if I did the non-dash pull way and cut the pipes, since they are in a such small space, I was worried if they would move little and gradually create a leak again between the pipes and rubber tube since the pipes do not have beads to "properly" hold on to the connecting tube....
Follow Ups	heater core replacement success rate - pearlwhite 09:59:27 10/14/14 I've pulled the dash for it - Stadsport (Nick@CZP) 17:42:05 10/14/14 Huh? I did the core by removing the dash, there was - jzack 18:31:11 10/14/14 is there a writeup for removing the dash? - wickdGSXR 09:56:17 10/17/14 There is a good diagram in the back of the FSM - Broke_as_**** 20:32:13 10/17/14 There is no need to remove the evaporator. - ILoveBoost 08:13:44 10/15/14 I've done the non-dash pull way 3 times now. - Woody75 (Denver) 12:42:34 10/15/14 Re: I've done the non-dash pull way 3 times now. - pearlwhite 16:53:26 10/16/14
Post a Followup	You cannot reply to this message because you are not logged in.