Subject	Re: Heads are 0.0015" out. Get decked or let 'em rip?
Posted by	MaxxAction on September 19, 2014 at 7:32 PM
	This message has been viewed 130 times.
In Reply To	Heads are 0.0015" out. Get decked or let 'em rip? posted by ZUL8R on September 19, 2014 at 02:42 PM
Message	that's a lot... If the block is decked too, you are going to find that your timing, while being aligned, is off. You would need to degree your cams. It might give you trouble getting the tensioner to set correctly too.
Follow Ups	Heads are 0.0015" out. Get decked or let 'em rip? - ZUL8R 14:42:13 09/19/14 What does the block check? - -Grimm- 16:33:05 09/19/14 Re: Heads are 0.0015" out. Get decked or let 'em rip? - MaxxAction 19:32:58 09/19/14 I think you misread the decimal (n/m) - -Grimm- 18:56:40 09/20/14 Re: I think you misread the decimal - MaxxAction 19:09:09 09/22/14
Post a Followup	You cannot reply to this message because you are not logged in.