Subject	What does the block check?
Posted by	-Grimm- on September 19, 2014 at 4:33 PM
	This message has been viewed 132 times.
In Reply To	Heads are 0.0015" out. Get decked or let 'em rip? posted by ZUL8R on September 19, 2014 at 02:42 PM
Message	Also, I assume a 0.002" wouldn't fit but 0.0015 would? (Meaning you're 0.0015-0.002 on technicality) Personally, I wouldn't sweat 0.0015" on the head deck surface. That small discrepancy will conform to the gasket when you torque everything up. ------------------------------------------------------------------ 1992 300ZX NA 5 Sp (Dead) 1990 300ZX NA Auto 2+2 (Dead) 1990 300ZX TT 5 Sp (Est. 400 HP) 1990 300ZX TT 5 Sp (Est. 600 HP) 2004 G35 Sport 6MT (DD)
Follow Ups	Heads are 0.0015" out. Get decked or let 'em rip? - ZUL8R 14:42:13 09/19/14 What does the block check? - -Grimm- 16:33:05 09/19/14 Re: Heads are 0.0015" out. Get decked or let 'em rip? - MaxxAction 19:32:58 09/19/14 I think you misread the decimal (n/m) - -Grimm- 18:56:40 09/20/14 Re: I think you misread the decimal - MaxxAction 19:09:09 09/22/14
Post a Followup	You cannot reply to this message because you are not logged in.