TwinTurbo.NET: Nissan 300ZX forum - Heads are 0.0015" out. Get decked or let 'em rip?
Subject
Heads are 0.0015" out. Get decked or let 'em rip?
Posted by
ZUL8R
on September 19, 2014 at 2:42 PM
This message has been viewed
156
times.
Message
I think the FSM says up to 0.002". If it run them at 0.0015, am I taking no risk, minimal risk, or moderate risk? Thank you.
Andy
Follow Ups
Heads are 0.0015" out. Get decked or let 'em rip? -
ZUL8R
14:42:13 09/19/14
What does the block check?
-
-Grimm-
16:33:05 09/19/14
Re: Heads are 0.0015" out. Get decked or let 'em rip?
-
MaxxAction
19:32:58 09/19/14
I think you misread the decimal (n/m)
-
-Grimm-
18:56:40 09/20/14
Re: I think you misread the decimal
-
MaxxAction
19:09:09 09/22/14
Post a
Followup
You cannot reply to this message because you are not
logged in
.