Subject	A small amount
Posted by	ThisIsSparTTa on September 19, 2014 at 8:34 AM
	This message has been viewed 285 times.
In Reply To	Re: Rear end noise posted by ZTom on September 18, 2014 at 11:07 PM
Message	Pretty sure that was the first time the diff fluid had been changed. The magnetic end of the lower bolt had collected a fair amount of metal type shavings, but I wouldn't consider it excessive for 24 years and up to 200K miles of operation. I didn't notice any additional shavings in the fluid as it drained out.
Follow Ups	Rear end noise - ThisIsSparTTa 20:06:31 09/18/14 Re: Rear end noise - ZTom 23:07:22 09/18/14 A small amount - ThisIsSparTTa 08:34:16 09/19/14 I had my diff off two days ago..spun by hand - wickdGSXR 00:04:41 09/19/14 I may have to - ThisIsSparTTa 08:36:48 09/19/14 what about the heat shields at the rotors? (n/m) - aliaZ 09:29:05 09/19/14 Rotors and driveshaft are off, still makes noise. (n/m) - ThisIsSparTTa 09:57:03 09/19/14 Re: Rotors and driveshaft are off, still makes noise. - ZTom 11:10:39 09/19/14 Tips for bad wheel bearing? - ThisIsSparTTa 12:12:10 09/19/14 Wheel bearing would be better than a diff rebuild - -Grimm- 13:23:11 09/19/14 Re: spin the wheel if it make grinding noise then - ZTom 13:31:57 09/19/14 glad you found it. I ordered bearings today - wickdGSXR 15:38:30 09/19/14 Re: glad you found it. I ordered bearings today - ZTom 20:31:10 09/19/14 Axles disconnected, its definitely just the diff grinding - ThisIsSparTTa 22:54:12 09/19/14 Sounds like pinion bearing is shot (n/m) - BarryGZX 00:49:16 09/22/14
Post a Followup	You cannot reply to this message because you are not logged in.