Subject	Re: Did you have any work done to the block?
Posted by	Snake9289 on September 16, 2014 at 10:10 AM
	This message has been viewed 149 times.
In Reply To	Did you have any work done to the block? posted by -Grimm- on September 16, 2014 at 09:51 AM
Message	Yes i check it was flat but no decking. But its like the colant path was block and make it way by eating the gasket its not the usual job where you see the collant pass under the gasket i saw the metal layer of thr gasket where the collant *eat* the graphite and go to the metal ring ...
Follow Ups	headgasket leak after 15min rebuild - Snake9289 07:31:42 09/16/14 I cant believe you missed anything during a 15minute rebuild - whamo 09:42:37 09/16/14 Did you have any work done to the block? - -Grimm- 09:51:30 09/16/14 Re: Did you have any work done to the block? - Snake9289 10:10:16 09/16/14 Checked with a machined straight edge? (n/m) - ttsmokin 13:23:43 09/16/14 Your over thinking this. A blocked port isnt going to cause - whamo 14:26:04 09/16/14 No, plus it isnt the only port, so the coolant - -Grimm- 15:28:07 09/16/14
Post a Followup	You cannot reply to this message because you are not logged in.