Subject	If you are talking about ignition timing
Posted by	-Grimm- on August 30, 2014 at 12:33 PM
	This message has been viewed 131 times.
In Reply To	Obviously this is your first time around.. posted by Cjw3 on August 30, 2014 at 12:29 PM
Message	The best you can do it leave the CAS in the bracket and pull it off as one piece. That should get it within a degree of where it was. If you're talking about cam timing (timing belt alignment) it just takes attention to detail. ------------------------------------------------------------------ 1992 300ZX NA 5 Sp (Dead) 1990 300ZX NA Auto 2+2 (Dead) 1990 300ZX TT 5 Sp (Building) 2004 G35 Sport 6MT (DD)
Follow Ups	How to replace head gasket with engine out. Keeping timing? - ZUL8R 20:11:13 08/29/14 Obviously this is your first time around.. - Cjw3 12:29:27 08/30/14 If you are talking about ignition timing - -Grimm- 12:33:52 08/30/14 Set your #1 piston to TDC and your crank pulley to align - SammybTT(TN) 12:33:32 08/30/14 Thanks guys. I have cyl 1 @ TDC and all marks seem aligned - ZUL8R 21:54:45 08/30/14 The cams are going to come out with the heads. - ZXoltan 04:55:13 08/31/14 Thanks gents. Any thoughts on this deck and gasket? - ZUL8R 23:57:17 09/01/14 sorry - 5 is bottom of pic, not top. (n/m) - ZUL8R 23:59:15 09/01/14 Doesnt look too horrible - -Grimm- 17:18:54 09/02/14 Thanks sir. Can I use OEM HG if heads get shaved? - ZUL8R 21:49:24 09/02/14 Factory states 0.008" is the deck limit - -Grimm- 09:41:43 09/03/14 Thanks Grimm. Don't the Cometics have a high failure rate? (n/m) - ZUL8R 12:12:46 09/03/14 Thanks Grimm. Don't the Cometics have a high failure rate? (n/m) - ZUL8R 13:08:23 09/03/14
Post a Followup	You cannot reply to this message because you are not logged in.