TwinTurbo.NET: Nissan 300ZX forum - Set your #1 piston to TDC and your crank pulley to align
People Seeking Info
 
   


     
Subject Set your #1 piston to TDC and your crank pulley to align
     
Posted by SammybTT(TN) on August 30, 2014 at 12:33 PM
  This message has been viewed 137 times.
     
In Reply To How to replace head gasket with engine out. Keeping timing? posted by ZUL8R on August 29, 2014 at 08:11 PM
     
Message With 0 degrees before head removal. After reinstall you will align cam gears with back plate for a reference then count the belt teeth during reassembly. The marks on the belt will align with the notches on the gears. It's not too difficult just take your time and double check

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.