Subject	Remove lockout assembly?
Posted by	Z32CheekiBreeki on August 23, 2014 at 6:46 PM
	This message has been viewed 433 times.
In Reply To	Manual Transmission Wont Go Into Reverse posted by Z32CheekiBreeki on August 23, 2014 at 04:17 PM
Message	Little Update: Trying to get the reverse lockout/checking assembly to check that, can remove the 10mm bolt fine but it's sealed tight to the tranny. Any ideas on removing it? Will using some PB blaster hurt anything?
Follow Ups	Manual Transmission Wont Go Into Reverse - Z32CheekiBreeki 16:17:34 08/23/14 Remove lockout assembly? - Z32CheekiBreeki 18:46:47 08/23/14
Post a Followup	You cannot reply to this message because you are not logged in.