TwinTurbo.NET: Nissan 300ZX forum - Re: I did new bearing but did not grease. Is there anything
Subject
Re: I did new bearing but did not grease. Is there anything
Posted by
ZTom
on July 25, 2014 at 4:55 PM
This message has been viewed
75
times.
In Reply To
I did new bearing but did not grease. Is there anything
posted by Coldfusown
on July 25, 2014 at 01:45 PM
Message
Sorry you did screw yourself. The shaft go into it so what you can do is slide the trans back enough so you could grease it but again it's hard to tell without having your Z here. But if u have time it's worth doing it.
Follow Ups
Disengage clutch noise - A humming type noise
-
Coldfusown
11:13:17 07/25/14
Re: Disengage clutch noise - A humming type noise
-
ZTom
12:30:47 07/25/14
And did you (lightly) grease said bearing? (n/m)
-
-Grimm-
12:45:31 07/25/14
I did new bearing but did not grease. Is there anything
-
Coldfusown
13:45:16 07/25/14
Re: I did new bearing but did not grease. Is there anything -
ZTom
16:55:40 07/25/14
Post a
Followup
You cannot reply to this message because you are not
logged in
.