TwinTurbo.NET: Nissan 300ZX forum - Re: Now this opens up another discussion...
Subject
Re: Now this opens up another discussion...
Posted by
jem_usmc
on July 22, 2014 at 4:33 PM
This message has been viewed
109
times.
In Reply To
Now this opens up another discussion...
posted by -Grimm-
on July 22, 2014 at 04:22 PM
Message
I'm focused on the drivers bank right now. In my last post I said I replaced the lifters in the drivers side. I replaced the lifters in the passenger side. Guys I've done so many things to this car over the past 4 months lol
Follow Ups
Fires on 3 cyls. The maf determines what side
-
jem_usmc
17:33:39 07/21/14
How did you determine the maf was bad?
-
ttsmokin
22:27:05 07/21/14
Re: How did you determine the maf was bad?
-
jem_usmc
04:52:10 07/22/14
Did you bleed the lifters after you put them back together?
-
ttsmokin
14:23:30 07/22/14
Now this opens up another discussion...
-
-Grimm-
16:22:01 07/22/14
Re: Now this opens up another discussion... -
jem_usmc
16:33:12 07/22/14
Ash's lifter rebuild guide:
-
ttsmokin
18:44:25 07/22/14
Re: Did you bleed the lifters after you put them back together?
-
jem_usmc
16:28:12 07/22/14
Re: Re: Did you bleed the lifters after you put them back together?
-
jem_usmc
16:46:22 07/22/14
Re: Re: Re: Did you bleed the lifters after you put them back together?
-
jem_usmc
16:59:46 07/22/14
When you installed the injectors...
-
ttsmokin
18:54:13 07/22/14
Re: When you installed the injectors...
-
jem_usmc
20:25:00 07/22/14
I would imagine WD-40 is not the best for that
-
ttsmokin
21:14:09 07/22/14
Re: I would imagine WD-40 is not the best for that
-
jem_usmc
20:38:11 07/23/14
Post a
Followup
You cannot reply to this message because you are not
logged in
.