Subject	Did you bleed the lifters after you put them back together?
Posted by	ttsmokin on July 22, 2014 at 2:23 PM
	This message has been viewed 117 times.
In Reply To	Re: How did you determine the maf was bad? posted by jem_usmc on July 22, 2014 at 04:52 AM
Message	By depressing the little check ball and letting them fill up with oil? There is a write up on how to do it. So now you have 170psi compression on all cylinders, correct?
Follow Ups	Fires on 3 cyls. The maf determines what side - jem_usmc 17:33:39 07/21/14 How did you determine the maf was bad? - ttsmokin 22:27:05 07/21/14 Re: How did you determine the maf was bad? - jem_usmc 04:52:10 07/22/14 Did you bleed the lifters after you put them back together? - ttsmokin 14:23:30 07/22/14 Now this opens up another discussion... - -Grimm- 16:22:01 07/22/14 Re: Now this opens up another discussion... - jem_usmc 16:33:12 07/22/14 Ash's lifter rebuild guide: - ttsmokin 18:44:25 07/22/14 Re: Did you bleed the lifters after you put them back together? - jem_usmc 16:28:12 07/22/14 Re: Re: Did you bleed the lifters after you put them back together? - jem_usmc 16:46:22 07/22/14 Re: Re: Re: Did you bleed the lifters after you put them back together? - jem_usmc 16:59:46 07/22/14 When you installed the injectors... - ttsmokin 18:54:13 07/22/14 Re: When you installed the injectors... - jem_usmc 20:25:00 07/22/14 I would imagine WD-40 is not the best for that - ttsmokin 21:14:09 07/22/14 Re: I would imagine WD-40 is not the best for that - jem_usmc 20:38:11 07/23/14
Post a Followup	You cannot reply to this message because you are not logged in.