Subject	PCV system ok? (n/m)
Posted by	BarryGZX on May 01, 2014 at 7:25 PM
	This message has been viewed 433 times.
In Reply To	The most frustrating and elusive idle problem ever posted by Silens on May 01, 2014 at 01:05 PM
Message
Follow Ups	The most frustrating and elusive idle problem ever - Silens 13:05:58 05/01/14 What kind of intake do you have? Stock, JWT, etc. (n/m) - SirpriZ 15:45:14 05/01/14 Just stock with a filter, no airbox. (n/m) - Silens 16:46:11 05/01/14 Does your set up use a low speed drivability hose? (n/m) - SirpriZ 17:15:32 05/01/14 Not that I'm aware of. - Silens 17:22:57 05/01/14 The problem that I had in mind would only occur if you have - SirpriZ 17:23:38 05/01/14 nope, I wish lol. - Silens 17:45:10 05/01/14 Sounds like either the throttle plates are too far closed, - Greg D. (Specialty-Z) 18:16:48 05/01/14 Re: Sounds like either the throttle plates are too far closed, - Silens 12:04:15 05/02/14 PCV system ok? (n/m) - BarryGZX 19:25:37 05/01/14 Re: PCV system ok? - Silens 12:04:51 05/02/14 You say Wideband.. Only One? - Cjw3 11:53:39 05/02/14 Re: You say Wideband.. Only One? - Silens 12:06:58 05/02/14 Re: Re: You say Wideband.. Only One? - Cjw3 12:38:19 05/02/14 you should check your narrow bands - Zvil (FL) 00:38:26 05/03/14 Re: you should check your narrow bands - Cjw3 08:34:38 05/03/14 stock 02 sensors are used during closed loop only = idle (n/m) - The Devils Z 19:42:23 05/03/14 Re: stock 02 sensors are used during closed loop only = idle - Cjw3 23:13:17 05/03/14 you may be right -- it get it backwords - but they are only - The Devils Z 11:25:39 05/04/14 I believe initial start up until prescribed temp is open - SirpriZ 15:32:06 05/04/14 Idle is ALWAYS in Open Loop.. Read the Book (n/m) - Cjw3 16:39:08 05/04/14 my Z must have an abnormal quirk then - Zvil (FL) 16:52:50 05/05/14 "idle" is when the ECU sets the ignition timing at 15 - Cjw3 19:36:24 05/05/14 Depends on the tune....... - Greg D. (Specialty-Z) 17:48:12 05/06/14 Well, my 3 NA's are open loop at idle.. I've watched - Cjw3 20:42:14 05/06/14 If your running a factory tune........... - Greg D. (Specialty-Z) 21:06:03 05/06/14 mind = blown...I bow to the sensei :) (n/m) - Zvil (FL) 22:07:08 05/06/14 Very Nice.. - Cjw3 23:33:32 05/06/14 Look inside for post and u-tube by customer showing idle.... - Greg D. (Specialty-Z) 13:54:43 05/07/14
Post a Followup	You cannot reply to this message because you are not logged in.