Subject	Sounds like either the throttle plates are too far closed,
Posted by	Greg D. (Specialty-Z) on May 01, 2014 at 6:16 PM
	This message has been viewed 399 times.
In Reply To	The most frustrating and elusive idle problem ever posted by Silens on May 01, 2014 at 01:05 PM
Message	or you have carbon build up on the throttle bodies limiting the idle flow. I would pull the throttle body hoses and clean. If clean, crack the idle rest screws sightly, reset TPS and base idle.
Follow Ups	The most frustrating and elusive idle problem ever - Silens 13:05:58 05/01/14 What kind of intake do you have? Stock, JWT, etc. (n/m) - SirpriZ 15:45:14 05/01/14 Just stock with a filter, no airbox. (n/m) - Silens 16:46:11 05/01/14 Does your set up use a low speed drivability hose? (n/m) - SirpriZ 17:15:32 05/01/14 Not that I'm aware of. - Silens 17:22:57 05/01/14 The problem that I had in mind would only occur if you have - SirpriZ 17:23:38 05/01/14 nope, I wish lol. - Silens 17:45:10 05/01/14 Sounds like either the throttle plates are too far closed, - Greg D. (Specialty-Z) 18:16:48 05/01/14 Re: Sounds like either the throttle plates are too far closed, - Silens 12:04:15 05/02/14 PCV system ok? (n/m) - BarryGZX 19:25:37 05/01/14 Re: PCV system ok? - Silens 12:04:51 05/02/14 You say Wideband.. Only One? - Cjw3 11:53:39 05/02/14 Re: You say Wideband.. Only One? - Silens 12:06:58 05/02/14 Re: Re: You say Wideband.. Only One? - Cjw3 12:38:19 05/02/14 you should check your narrow bands - Zvil (FL) 00:38:26 05/03/14 Re: you should check your narrow bands - Cjw3 08:34:38 05/03/14 stock 02 sensors are used during closed loop only = idle (n/m) - The Devils Z 19:42:23 05/03/14 Re: stock 02 sensors are used during closed loop only = idle - Cjw3 23:13:17 05/03/14 you may be right -- it get it backwords - but they are only - The Devils Z 11:25:39 05/04/14 I believe initial start up until prescribed temp is open - SirpriZ 15:32:06 05/04/14 Idle is ALWAYS in Open Loop.. Read the Book (n/m) - Cjw3 16:39:08 05/04/14 my Z must have an abnormal quirk then - Zvil (FL) 16:52:50 05/05/14 "idle" is when the ECU sets the ignition timing at 15 - Cjw3 19:36:24 05/05/14 Depends on the tune....... - Greg D. (Specialty-Z) 17:48:12 05/06/14 Well, my 3 NA's are open loop at idle.. I've watched - Cjw3 20:42:14 05/06/14 If your running a factory tune........... - Greg D. (Specialty-Z) 21:06:03 05/06/14 mind = blown...I bow to the sensei :) (n/m) - Zvil (FL) 22:07:08 05/06/14 Very Nice.. - Cjw3 23:33:32 05/06/14 Look inside for post and u-tube by customer showing idle.... - Greg D. (Specialty-Z) 13:54:43 05/07/14
Post a Followup	You cannot reply to this message because you are not logged in.