Subject	I am having serious performance issues!
Posted by	Stanky on April 23, 2014 at 2:10 PM
	This message has been viewed 168 times.
In Reply To	Have you verified your pulley mark is accurate? posted by -Grimm- on April 23, 2014 at 12:21 PM
Message	Made a thread a week ago or so about my dyno tune and my lack of power and spool. Pulley seemed to be on right and when at Tdc the mark was at the 0.
Follow Ups	Timing belt marks - Stanky 00:02:33 04/23/14 Re: Timing belt marks - Stadsport (Nick@CZP) 00:06:26 04/23/14 Re: Re: Timing belt marks - Lue's Student 13:23:38 04/23/14 2nd for counting. Avoid the headaches (n/m) - ThisIsSparTTa 15:13:31 04/23/14 You will need to mark the belt and start counting. - Woody75 (Denver) 09:33:39 04/23/14 That looks fine - -Grimm- 09:41:37 04/23/14 hmm, when we hooked up the timing light we were getting - Stanky 12:12:44 04/23/14 Have you verified your pulley mark is accurate? - -Grimm- 12:21:09 04/23/14 I am having serious performance issues! - Stanky 14:10:46 04/23/14 Did you try turning the pick up on the gun over 180 degrees? (n/m) - Woody75 (Denver) 12:24:55 04/23/14 Im not sure, I had a local Z friend have a quick look at it - Stanky 14:21:04 04/23/14 Some guns will either show an advanced or retarded signal. - Woody75 (Denver) 16:26:32 04/23/14 hmm, when we hooked up the timing light we were getting - Stanky 14:07:40 04/23/14
Post a Followup	You cannot reply to this message because you are not logged in.