Subject	gaskets for decked head
Posted by	DaZedMan on April 22, 2014 at 9:00 PM
	This message has been viewed 154 times.
Message	twin turbo motor in new project apparently was run hot and warped one of the heads; other head was OK. Machine shop took .008" off to flatten the surface. I'm assuming I'll need to use a thicker head gasket (.051") to make up the removed thickness. Question is: do I need to use a stock thickness Cometic gasket on the uncut head to match the thicker Cometic gasket, or can I use a stock Nissan head gasket?
Follow Ups	gaskets for decked head - DaZedMan 21:00:58 04/22/14 You had one head decked? - -Grimm- 09:40:02 04/23/14
Post a Followup	You cannot reply to this message because you are not logged in.