Subject	intake manifold stripped
Posted by	aztec300z on April 21, 2014 at 10:39 PM
	This message has been viewed 151 times.
Message	OK so I replaced my plenum gasket but when I was putting it back I found out that I have 2 stripped out intake manifold holes how can I fix it I'm About to just drill a bigger hole 3/8 to be exact but I just found out about the ezloks does anyone know if that would work or any other way easier than this Thank you in advance
Follow Ups	intake manifold stripped - aztec300z 22:39:15 04/21/14 before you do anything else, get a torque wrench to avoid - aliaZ 06:42:10 04/22/14 Re: before you do anything else, get a torque wrench to avoid - aztec300z 21:18:12 04/23/14 Helicoil-ed mine. Works great (n/m) - ThisIsSparTTa 08:41:15 04/22/14 Same - -Grimm- 09:22:38 04/22/14
Post a Followup	You cannot reply to this message because you are not logged in.