Subject	Welcome answers below
Posted by	SammybTT(TN) on April 21, 2014 at 8:40 PM
	This message has been viewed 154 times.
In Reply To	oil in intercooler/piping, valve covers, posted by tribalchild1 on April 21, 2014 at 01:42 PM
Message	1. As Krazyd27 recommends check the PCV for proper operation. 2. Same thing happened to my valve covers, these small brittle parts allow for oil drainage. I can't remember the TT.net members name but as he implied it is better for them to break before installing the covers and having the part fall into the valve train. Some people actually remove them. If these were sandblasted before PC be sure that all of the sand and debris is removed before reinstalling especially under the baffle plates. 3. Test pipe and exhaust diameter requirements are dependent upon the HP level. My understanding 2.5" is good up to 600 HP. Hope this helps
Follow Ups	oil in intercooler/piping, valve covers, - tribalchild1 13:42:46 04/21/14 forgot to post exhaust question - tribalchild1 13:51:20 04/21/14 Check your PCV valves (n/m) - Krazyd27(Houston) 14:55:55 04/21/14 Welcome answers below - SammybTT(TN) 20:40:09 04/21/14 so if i understand you correctly - tribalchild1 15:40:12 04/24/14 Yes and yes - SammybTT(TN) 22:30:44 04/24/14 There can't be more - tribalchild1 15:58:19 04/25/14 With the additional information I would suspect the - SammybTT(TN) 18:04:41 04/25/14
Post a Followup	You cannot reply to this message because you are not logged in.