Subject	Re: Try wiggling or cleaning the CAS connector. My Z quit >
Posted by	mfergus2000 on April 05, 2014 at 10:10 PM
	This message has been viewed 194 times.
In Reply To	Try wiggling or cleaning the CAS connector. My Z quit > posted by my91z on April 05, 2014 at 08:50 PM
Message	There was no wiggle room on the CAS sensor. It was tight and locked in place. I did remove the connector however and cleaned it. Still no firing of the engine.
Follow Ups	Car Won't Start 91TT - mfergus2000 19:44:10 04/05/14 Is the starter bad? - -Grimm- 19:58:36 04/05/14 Re: Is the starter bad? - mfergus2000 20:24:44 04/05/14 Check your PTU. (n/m) - Tanley 20:44:12 04/05/14 Re: Check your PTU. - mfergus2000 22:06:48 04/05/14 Re: Re: Check your PTU. - mfergus2000 22:08:19 04/05/14 Try wiggling or cleaning the CAS connector. My Z quit > - my91z 20:50:44 04/05/14 Re: Try wiggling or cleaning the CAS connector. My Z quit > - mfergus2000 22:10:10 04/05/14 Have you checked injectors? - Zinister1 08:48:37 04/06/14 Re: Have you checked injectors? - mfergus2000 09:26:15 04/06/14 You can pull a plug, then leave it attached to the coilpack> - my91z 12:59:26 04/06/14
Post a Followup	You cannot reply to this message because you are not logged in.