Subject	Courtesy of DVDburn
Posted by	Summeronthechain (MN) on May 23, 2013 at 9:51 PM
	This message has been viewed 319 times.
In Reply To	Speed sensor wireing/path posted by mikuZ on May 23, 2013 at 05:37 PM
Message	If your gauge cluster is out look at the back of the gauge cluster right behind the speedometer. You'll see 4 screws that hold the speedometer gauge to the cluster. Each of those screws is marked. The one that says 2P next to it is the one that sends the speed signal to the ECU. The one that says Sig is the speed signal input from the speed sensor.
Follow Ups	Speed sensor wireing/path - mikuZ 17:37:36 05/23/13 Courtesy of DVDburn - Summeronthechain (MN) 21:51:09 05/23/13 Re: Courtesy of DVDburn - mikuZ 04:38:08 05/24/13 Re: Re: Courtesy of DVDburn - mikuZ 14:18:04 05/24/13 Your board is bad. - DVDBURN (MD) 15:31:31 05/24/13 Re: Your board is bad. - mikuZ 16:29:54 05/24/13 Probably not (n/m) - Summeronthechain (MN) 17:42:20 05/24/13 Re: Your board is bad. - mikuZ 17:06:25 05/25/13 Re: Speed sensor wireing/path - mikuZ 15:50:45 07/02/13
Post a Followup	You cannot reply to this message because you are not logged in.