Subject	Speed sensor wireing/path
Posted by	mikuZ on May 23, 2013 at 5:37 PM
	This message has been viewed 389 times.
Message	Does anyone know how speed sensor signal is leaving gauge cluster? My power steering is not working, happens under acceleration. HICAS light comes on, I used HICAS diagnostic and it's giving me speed sensor, also when I connected Conzult it's showing no speed signal. However my speedometer is working and odometer is working. tested them against GPS, all turned out fine. Also I resoldered all connections on speedometer cluster, that didn't help. So as far as I know, signal goes like this: speed sensor -> gauge cluster -> ECU -> HICAS/PS. I'm guessing wire between cluster and ECU is the problem, but I have no idea what wire it's using to leave cluster.
Follow Ups	Speed sensor wireing/path - mikuZ 17:37:36 05/23/13 Courtesy of DVDburn - Summeronthechain (MN) 21:51:09 05/23/13 Re: Courtesy of DVDburn - mikuZ 04:38:08 05/24/13 Re: Re: Courtesy of DVDburn - mikuZ 14:18:04 05/24/13 Your board is bad. - DVDBURN (MD) 15:31:31 05/24/13 Re: Your board is bad. - mikuZ 16:29:54 05/24/13 Probably not (n/m) - Summeronthechain (MN) 17:42:20 05/24/13 Re: Your board is bad. - mikuZ 17:06:25 05/25/13 Re: Speed sensor wireing/path - mikuZ 15:50:45 07/02/13
Post a Followup	You cannot reply to this message because you are not logged in.