Subject	PTU Testing...
Posted by	PiotrC70 on March 31, 2013 at 5:56 PM
	This message has been viewed 996 times.
In Reply To	Occasional miss and moving timing. posted by PiotrC70 on March 31, 2013 at 02:19 PM
Message	Okay, hopefully I'm not over thinking all this but rather just being thorough. I know some of the most difficult problems have the easiest answers but here goes.... I took out my PTU and test it as follows. [ http://www.300zx-twinturbo.com/cgi-bin/manual.cgi?list=efec&dir=&config=&refresh=&direction=forward&scale=0&cycle=off&slide=179&design=default&total=190 ] I have my fluke set to continuity (solid beep when there is continuity) OL when there isn't... I get NO continuity where it states I should. In fact, on one of the combinations, I actually get like 5xx ohms. I've been looking everywhere for my other PTU and can't find it so I'm stuck for now until a friend can check his. 1993 TT. R.I.P. 09.15.2010
Follow Ups	Occasional miss and moving timing. - PiotrC70 14:19:19 03/31/13 Almost forgot: Checked and got no codes (only 55) (n/m) - PiotrC70 14:48:34 03/31/13 Have you tried checking timing using different methods? - Evan_Wright (Ca) 15:01:00 03/31/13 After the build, I didn't have any luck with the #1 coil. - PiotrC70 16:03:44 03/31/13 I would suggest you make up a plug wire extension - ttsmokin 17:15:31 03/31/13 I've read that people that have switched to a '95 CAS - PiotrC70 17:25:17 03/31/13 PTU Testing... - PiotrC70 17:56:43 03/31/13 PTU = Good. A friend suggested I check the newer FSM's - PiotrC70 19:25:34 04/01/13
Post a Followup	You cannot reply to this message because you are not logged in.