Subject	Slippage
Posted by	Drk93TT on November 05, 2012 at 9:35 PM
	This message has been viewed 337 times.
In Reply To	Clutch slipping on aluminum flywheel posted by ZXER on November 05, 2012 at 08:40 PM
Message	Try to bleed the clutch entirely off the fender bleeder.. go thru about a 1/4 quart of fluid. Do you have any adjustment left in the master rod or is it on the floor?? Make sure you have plenty of freeplay at the top.. about an inch before engagement. Did you break it long enough..? If it was adjusted wrong from the get-go it may be smoked.
Follow Ups	Clutch slipping on aluminum flywheel - ZXER 20:40:48 11/05/12 I believe you may have air in your clutch lines that is - Evan_Wright (Ca) 20:52:06 11/05/12 Re: I believe you may have air in your clutch lines that is - ZXER 21:28:30 11/05/12 Yup (n/m) - Evan_Wright (Ca) 23:33:00 11/05/12 Slippage - Drk93TT 21:35:50 11/05/12 Re: Slippage - ZXER 08:15:15 11/06/12 In the engine bay - Summeronthechain (MN) 08:43:41 11/06/12 Re: In the engine bay - ZXER 10:53:56 11/06/12 Re: Slippage - ZXER 10:52:23 11/06/12 Re: Clutch slipping on aluminum flywheel - stewart_customs 17:32:52 11/06/12 Adjust and details why.................. - Greg D. (Specialty-Z) 20:41:18 11/06/12 Link to our clutch adjustment page - Greg D. (Specialty-Z) 20:47:20 11/06/12 Re: Adjust and details why.................. - ZXER 15:44:15 11/08/12
Post a Followup	You cannot reply to this message because you are not logged in.