Subject	Clutch slipping on aluminum flywheel
Posted by	ZXER on November 05, 2012 at 8:40 PM
	This message has been viewed 333 times.
Message	I have a Fidanza flywheel and an ACT clutch and pressure plate. My problem is it is slipping a lot. I'll adjust it, and it engages right off from the floorboard, and after about an hour of driving then it starts engaging at the opposite end to the point that I can get it to slip in any gear just by stepping on the accelerator. I have adjusted it over and over and it just continues to do this, and since it's almost new I know it's not from wear.
Follow Ups	Clutch slipping on aluminum flywheel - ZXER 20:40:48 11/05/12 I believe you may have air in your clutch lines that is - Evan_Wright (Ca) 20:52:06 11/05/12 Re: I believe you may have air in your clutch lines that is - ZXER 21:28:30 11/05/12 Yup (n/m) - Evan_Wright (Ca) 23:33:00 11/05/12 Slippage - Drk93TT 21:35:50 11/05/12 Re: Slippage - ZXER 08:15:15 11/06/12 In the engine bay - Summeronthechain (MN) 08:43:41 11/06/12 Re: In the engine bay - ZXER 10:53:56 11/06/12 Re: Slippage - ZXER 10:52:23 11/06/12 Re: Clutch slipping on aluminum flywheel - stewart_customs 17:32:52 11/06/12 Adjust and details why.................. - Greg D. (Specialty-Z) 20:41:18 11/06/12 Link to our clutch adjustment page - Greg D. (Specialty-Z) 20:47:20 11/06/12 Re: Adjust and details why.................. - ZXER 15:44:15 11/08/12
Post a Followup	You cannot reply to this message because you are not logged in.